Need professional heating and cooling services in Rhinebeck, NY? Look no further! Folkes Home Services, Cooling & Burner Service provides expert services from highly trained technicians. We work for your comfort and satisfaction.
Check out our customer reviews below to see examples of our high quality work. Choose Folkes as your HVAC specialist in Rhinebeck, NY.
Local Reviews
for Rhinebeck, NY
Powered by Nearby Now
Excellent
Hassan - Rhinebeck, NY
Terrific service Excellent Diagnostics
Jessica - Rhinebeck, NY
Quick, Friendly, and Patient!
Jeremy - Rhinebeck, NY
Danny did a fantastic job. He explained everything to me clearly and he taught me how to clean the filters in my HVAC system. He was patient with my many questions, very friendly, and very personable. And lastly, he was so quick at evaluating and cleaning my HVAC system!
Great
Janice - Rhinebeck, NY
Your outfit gets a 10. Noah is a well trained professional
Great company
Susan - Rhinebeck, NY
Billy came to give me an estimate on replacing my AC condenser and furnace. He was terrific. Explained things very clearly, and the pros and cons of different options. Highly recommend.
Great service - fast, efficient, and informative
Kenneth - Rhinebeck, NY
Great Servicd!
Jeremy - Rhinebeck, NY
Response from Folkes Heating, Cooling and Burner Service:
Thank you!
Efficient and informative
Kenneth - Rhinebeck, NY
Response from Folkes Heating, Cooling and Burner Service:
We are here whenever you need us. Thank you.
Noah D.
Performed ac tune up. Replaced weak capacitor and installed new uv light.
Danny B.
System operational, found TXV not metering refrigerant properly on heat pump mode, part is no longer available due to system being an r-22 unit (parts have been discontinued), Recommend residential replacement.
Greg M.
Found primary control tripped on hard lockout. Reset and found boiler smoking and primary locking out after 45 sec. Opened boiler and found to be sooted due to not enough air to burner. Cleaned boiler, replaced nozzle and set up burner with combustion test kit.
Noah D.
Arrived and found burner locked out, reset and system ran for 5 seconds then shut down. This was the same issue as before. Turned the burner air band down slightly and the system ran fine. Tested the ohms from the primary control and they are at 300 ohms. If this happens again we may have to replace the primary control.
Noah D.
Arrived and performed ac tune up x3. Pulled apart 3 head units to clean the blower wheels and filters. Customer said they weren’t performing good and were never serviced really. Found a lot of dust on the filters and blower wheels. After cleaning everything, put components back and tested the system. No issues to report.
Tyler F.
Arrived at customers home for a couple issues with leaky faucets and toilet issue. Found two identical lav faucets that i could not get the caps off of without potietially damaging the faucet and without the replacement parts handy did not want to try to force. Also found the kitchen sink faucet leaking which needs a single handle delta rebuild kit. Also a toilet flapper which was repaired today with universal which slowed down the water usage significantly but is still leaking by very slowly advised the customer that if they move forward with work we order the proper flapper and bring it with us on the day of the work. Also found Shower valve leaking by as well which needs to be rebuilt as well. All faucets are deltas. Gave estimate for the work today only the flapper is being done.
Tyler F.
Arrived at customers home for a slow drain. Found the drain lines to be poorly done and that’s what’s causing issue gave customer estimate for fix. Customer also had a couple of issues going on she wanted to address gave separate estiMates for the work.
Noah D.
Found burner locked out. Reset and tried to relit. System would lite hen shut off shortly after. Tried jumping the cad cell eye out and the burner ran. Turned the air band down to richen the flame and the system stayed running. Took a smoke test after the adjustment.
Margaret M.
Cleaned and serviced AC system. Checked capacitors. Blower, condenser fan, and compressor amp readings. Checked air filter. Checked pressures on condenser. System operational
Scott Y.
C/S Oil. Replaced filter strainer nozzle. Brushed and cleaned boiler. Checked and cleaned electrodes, checked zone valves, thermostats, water feeder, primary, igniter, circulator, air vents, relief valve. Took combustion test, system running normally.
tonyp@folkeshomeservices.com
Completed annual clean and service of one oil fired boiler. Found boiler room flooded upon arrival. Upon further investigation found that the expansion tank had failed and relief valve was leaking. Found air vent and relief valve also heavily corroded. Made all necessary repairs and tested system several times. Performed combustion analysis and smoke test. No further issues to report at this time of service.
Margaret M.
1 gas & 1 A/C new MA
Noah D.
Performed heat pump tune up. No issues to to report.
Chris H.
Cleaned and serviced one oil fired furnace with MA. Changed filter nozzle and strainer, brushed heat exchanger and flue pipe, inspected blower wheel tested blower motor capacitor which tested in range, left 24x24x1 return filter for customer, took smoke test which system burning clean, and also took combustion and efficiency test which everything looked good. System operational and working. Customer signed up for maintenance agreement for 1 oil and 1 AC.
Greg M.
Found ductless heat pump on back porch making vibrating noise during run cycle. Fan guard vibrating. Checked fan blades for for objects, found none. Tightened fan guard and checked for noise.
Margaret M.
Estimate to relocate duct work.
Tyler F.
Arrived at customers home or a estimate on 4 bathroom renovations. Customer wants to Stewart with master and bathroom on the first floor. Will be in touch with estimate.
Noah D.
Customer had new Trane heat pump installed in June 2020. When he came home from Cape Cod last Tuesday the 22nd he found his emergency heat on. Customer had the same company come back to look at it and said it may be the eev valve or control boards. The indoor unit does come on and does work but upstairs there are many things that are not right. The condensate drain does not have a full trap on it, the secondary pan is connected into the primary pan drain so the spill switch will never go off. The braze spots on the line set are very messy. All the supply and return collars are almost falling off and not taped on properly. After going over the indoor unit the outdoor unit was found off, by pushing in he contactor I was able to get the unit running, there is no low voltage coming outside to power the condenser. Also the condenser coil does have some damage to it in areas, the rating plate was burnt off by the brazing done to it and the wiring was left in a loose bundle under some electri
Bryan C.
Upon arrival folkes home services found kitchen sink to be clogged. Folkes home services cabled drain and cleared drain drain is now draining properly.
Bryan C.
Upon arrival folkes home services found pipe disconnect under drawl space. Folkes also found that crawl space has sewage and standing water. Customer will have standing water removed and will contact us to fix broken pipe.
Scott Y.
Performed 2 ac systems under MA for new install and 2 systems with no contract. Checked pressures, cleared drains, checked and cleaned off coils, checked delta Ts, checked capacitors and contactors. wrote estimate to replace contactor for administrative building system, management will contact us at later date to give approval to replace part. All 4 systems are operating normally. Office will reach out to collect payment for today.
Danny B.
Ac Tune Up x2
Chris H.
Customer said fan wasn’t coming on this afternoon and wasn’t maintain temperature. Looked over unit changed Merv filter 20x20x4 which was pretty dirty, inside air handler looked good, tested pressures which were normal, went over thermostat with customer. System operational and working as it should. Please mail invoice to customer.
Noah D.
Found the blower not coming on, tested the board found it was good, thought it was the blower until I found a temperature switch in line with the cool wire on the blower. The switch is not needed on the system so I spliced the wires and connected them, the system worked good after that.
Scott Y.
Performed tune up for air conditioning. Checked delta t, evaporator coil, cleared trap, necked blower and wiring for air handler. Checked thermostat operation. Checked pressures, capacitor and contactor. System is operating normally.
